top of page
membran.png

Membrane Roof

In areas where wind load and slope are critical, drilling and studding may be necessary to maintain roof integrity. With proper installation, these methods can be successfully implemented without any leaks. Don't worry about applying on membrane roofs anymore! When done correctly, this membrane apparatus minimizes problems on your roof and provides a long-term solution.

Custom Design

Structural Analysis

Corrosion-Resistant

Easy Installation

Tilt-Adjustable

Long-lasting

membran v6.png

Design

From a design perspective, there is often a standardization similar to the I-profile. This is designed with the assumption that the panels and profiles will generally be mounted vertically.

image (1).png

Strength

In terms of strength, this profile solution has been developed with detailed part analysis while maintaining standardization.

m2.png

Assembly

The profiles are usually mounted to the roof using pointed-tip screws. Additionally, EPDM strips placed under each screw provide insulation for the system.

Material

The material and sections of the supporting system vary according to the project information and are made of ST-52 or ST-37 material.

System Angle

Designed in the range of 20-30 degrees according to the project.

Coating

Steel elements are coated with hot-dip galvanizing. The thickness varies according to the project.

Standart

ASCE 7-16, ANSI/AISC 360-10, ACI 318-14, EN 1993-1-1, EN 1991-1-1, EN 1990, TS500, TS 498,

Connection Elements

Aluminum clamps and steel flanged nuts are used.

Warranty

Our supporting systems come with a 2-year warranty.

bottom of page