.png)
Flat Roof - Non-Sloped
For flat roofs, we offer a wide range of system options based on panel placement and desired angles. Our primary focus for flat roof systems is to design cost-effective and easy-to-install systems. By going beyond standard solutions, these designs provide variety and flexibility, specifically developed to meet customer expectations.
Custom Design
Structural Analysis
Corrosion-Resistant
Easy Installation
Tilt-Adjustable
Long-lasting
.png)
Design
From a design perspective, there is often a standardization similar to the I-profile. This is designed with the assumption that the panels and profiles will generally be mounted vertically.
.png)
Strength
In terms of strength, this profile solution has been developed with detailed part analysis while maintaining standardization.
Assembly
The profiles are usually mounted to the roof using pointed-tip screws. Additionally, EPDM strips placed under each screw provide insulation for the system.
Material
The material and sections of the supporting system vary according to the project information and are made of ST-52 or ST-37 material.
System Angle
Designed in the range of 20-30 degrees according to the project.
Coating
Steel elements are coated with hot-dip galvanizing. The thickness varies according to the project.
Standart
ASCE 7-16, ANSI/AISC 360-10, ACI 318-14, EN 1993-1-1, EN 1991-1-1, EN 1990, TS500, TS 498,
Connection Elements
Aluminum clamps and steel flanged nuts are used.
Warranty
Our supporting systems come with a 2-year warranty.