top of page
t7.png

Trapezoidal Roof

One of the methods applied in our structures using trapezoidal sheet metal for roof cladding is known for its standardized approach. This system is applied to roofs with sufficient thickness to withstand tensile forces. In this system, which is implemented using full-length profiles, more screws (trapezoidal) than those used in sandwich panel installation are employed to provide adequate resistance to tensile forces. This method maintains the integrity of the roof while also enhancing structural safety.

Custom Design

Structural Analysis

Corrosion-Resistant

Easy Installation

Tilt-Adjustable

Long-lasting

corrugated steel sheet cladding v8.png

Design

From a design perspective, there is often a standardization similar to the I-profile. This is designed with the assumption that the panels and profiles will generally be mounted vertically.

image (1).png

Strength

In terms of strength, this profile solution has been developed with detailed part analysis while maintaining standards.

T9.png

Assembly

The profiles are usually mounted to the roof using pointed-tip screws. Additionally, EPDM strips placed under each screw provide insulation for the system.

Material

The material and sections of the supporting system vary according to the project information and are made of ST-52 or ST-37 material.

System Angle

Designed in the range of 20-30 degrees according to the project.

Coating

Steel elements are coated with hot-dip galvanizing. The thickness varies according to the project.

Standart

ASCE 7-16, ANSI/AISC 360-10, ACI 318-14, EN 1993-1-1, EN 1991-1-1, EN 1990, TS500, TS 498,

Connection Elements

Aluminum clamps and steel flanged nuts are used.

Warranty

Our supporting systems come with a 2-year warranty.

bottom of page